Manual Homemade Oil Press Machine Mills Expeller Extractor #304 Stainless Steel
Raw materials: 304 Stainless Steel. Packing size:15 x 11.8 x 3.5 inches. Home use oil press can be used at any time throughout the year for beans, peanut, rape seed.
Cotton seed, flax, sunflower seed, almond seed, Pumpkin seed, tea seed, sesame, etc many kinds of oil plants. The front and rear part of the work is ready to feed inlet. After pressing the start, there is a small amount of oil will flow from the adjusting screw at, which is a normal phenomenon. After pressing normal, bagasse material will be relatively dry mouth, squeezing normal.
After the bombing bore with oil, as the oil is not smooth, please cranks reverse a few times, and use a knife to clean up the oil port. Material friction and lamp heating cause very hot press cage, press cage cap and terminal adjustment bolt. Keep hands clear of the hot parts. And if you indeed need operate the hot parts please take reasonable protection steps.This machine consists of four main parts; frame, press cage, handle and heating part. The oil bottle can be replaced (and recycled)with standard household bottles. Before the use, thoroughly clean and dry all parts.
Start by affixing the frame to the L shaped metal piece. There are three pre-drilled holes on the L shaped metal piece and the frame. They should be aligned and secured with the provided bolts to form one piece. You should then fix the rack to a firm surface. Insert the bolts from the bottom, and fasten them until the. Frame is firmly secured to the table. You can use the provided round metal pieces to protect your table. And also act as a gap filler if your table edge is not thick enough. The handle: First affix the crank at the bottom of the handle. To the screw shaft at the end of the press cage and use the bolt to fasten it via the pre-drilled holes. Make sure the handle can rotate effortlessly and smoothly. On the front part of the press cage, you should fasten the press cage cap followed by the terminal adjustment bolt. Fuel bottle: The provided wick should be inserted into the metal cap with the pre drilled hole. Fill the bottle with kerosene or alcohol fuel (It should be 80% full). Leave 0.5cm of the wick outside and put the longer end in the fuel bottle. The fuel bottle under the press cage, towards the outside. Secure it with the rubber. Band so that the fuel bottle stays put and does not move during operation. Plastic oil bottle: Place the empty plastic oil bottle under the opening of the. The bottle will collect the usable oil. If you use your own bottle in the. Future, make sure it is heat proof.Inlet Plate: Fill the plate with the raw ingredient and let it sit at the top of the press cage. These charges are the buyers' responsibility. This item is in the category "Home & Garden\Kitchen, Dining & Bar\Kitchen Tools & Gadgets\Other Kitchen Tools & Gadgets". The seller is "etwj9331" and is located in this country: CN.
This item can be shipped worldwide.
- Texture of material: Stainless steel
- Manufacturer Color: Silver
- Color: Silver
- Custom Bundle: No
- Packing size: 15 x 11.8 x 3.5 inches
- Material: Stainless Steel
- Item Length: 10-15 in
- Brand: Unbranded
- Item Height: 13 in
- Making Method: Oil
- Country/Region of Manufacture: China
- Item Weight: 7 lb
- Item Width: Less Than 10 in