HD Manual Oil Press Machine Expeller Extractor Stainless Steel#304 Homemade oil. This machine consists of four main parts; frame, press cage. The oil bottle can be replaced (and recycled).
Before each use, thoroughly clean and dry all parts. Start by affixing the frame to the L shaped metal piece.
There are three pre-drilled holes on the L shaped metal piece and the frame. They should be aligned and secured with the provided bolts to form one piece.You should then fix the rack to a firm surface. Insert the bolts from the bottom. And fasten them until the frame is firmly secured to the table. You can use the provided round metal pieces to protect your table, and also act as a gap filler if your table edge is not thick enough. The handle: First affix the crank at the bottom of the handle. To the screw shaft at the end of the press cage and use the bolt to fasten it via the pre-drilled holes. Make sure the handle can rotate effortlessly and smoothly. On the front part of the press cage, you should fasten the press cage cap followed. By the terminal adjustment bolt. Fuel bottle: The provided wick should be inserted into the metal cap with the. Fill the bottle with kerosene or alcohol fuel (It should be 80% full).
Leave 0.5cm of the wick outside and put the longer end in the fuel bottle. The fuel bottle under the press cage, towards the outside. Secure it with the rubber. Band so that the fuel bottle stays put and does not move during operation. Plastic oil bottle: Place the empty plastic oil bottle under the opening of the.
The bottle will collect the usable oil. If you use your own bottle in the. Future, make sure it is heat proof. Inlet Plate: Fill the plate with the raw ingredient and let it sit at the top of the press cage. This item is in the category "Home & Garden\Kitchen, Dining & Bar\Kitchen Tools & Gadgets\Other Kitchen Tools & Gadgets".The seller is "dreamfactory5188" and is located in this country: CN. This item can be shipped worldwide.