The chambers are all shiny and bright. The Extractor glides freely, and the spring tension on the Center Pin and Extractor are both firm.
All components are in working order. There is absolutely no evidence whatsoever of any pitting or corrosion on any of the components of this assembly.ONLY COMPATIBLE with the original Model 66-2 revolvers, and some Late-production 66-1 Models that did not have the recessed Cylinder. This Assembly does NOT have the Recessed Chambers in the Cylinder. ALSO NOTE: Due to the length of the Extractor Rod on this Assembly, it will only be compatible to install on Model 66 Revolvers that have a 4-Inch or 6-Inch Barrel. Length of Extractor Rod is too long to fit in the slot on the bottom of a shorter 2 1/2-Inch barrel.... It MAY be compatible with the scarcely-seen 3-Inch Barreled Model 66's, but please consult a Gunsmith regarding fitment as we do not have access to a 3-Inch Barreled Model 66 to measure.
As with any vintage gun parts there may be minor imperfections and we have attempted to capture a fair rendition of the condition of the items in the image set. See photos for full description.
Exactly the Assembly as seen in this listing's photoset. A few of the images in the photoset are a collage of the same Assembly taken from two different perspectives: We simply had more images to share than the site's twelve maximum upload limit, so to confirm, this listing is for one. As all sales on gun parts are final.